Arduino 鼠标按钮控制

由 drbear 创建，youj 最后一次修改 2016-12-26 使用鼠标库，你可以使用Arduino Leonardo，Micro或Due来控制计算机的屏幕光标。这个特殊的例子使用五个按钮来移动屏幕上的光标。四个按钮是方向性的（上，下，左，右），一个是用于鼠标左键单击。来自Arduino的光标移动总是相对的。每次读取输入时，光标的位置都会相对于当前位置进行更新。只要有一个方向按钮被按下，Arduino就会移动鼠标，在合适的方向上将HIGH输入映射到5的范围。第五个按钮用于控制来自鼠标的左键单击。当按钮被释放时，计算机将识别事件。必需的组件你将需要以下组件： 1 × Breadboard 面包板1 × Arduino Leonardo, Micro 或 Due板5 × 10k欧姆电阻5 × 瞬时按钮程序按照电路图连接面包板上的组件，如下图所示。草图在计算机上打开Arduino IDE软件。使用Arduino语言进行编码控制你的电路。通过单击“New”打开一个新的草图文件。对于本例，你需要使用Arduino IDE 1.6.7Arduino代码/* Button Mouse Control For Leonardo and Due boards only .Controls the mouse from five pushbuttons on an Arduino Leonardo, Micro or Due. Hardware: * 5 pushbuttons attached to D2, D3, D4, D5, D6 The mouse movement is always relative. This sketch reads four pushbuttons, and uses them to set the movement of the mouse. WARNING: When you use the Mouse.move() command, the Arduino takes over your mouse! Make sure you have control before you use the mouse commands.*/#include "Mouse.h"// set pin numbers for the five buttons:const int upButton = 2;const int downButton = 3;const int leftButton = 4;const int rightButton = 5;const int mouseButton = 6;int range = 5; // output range of X or Y movement; affects movement speedint responseDelay = 10; // response delay of the mouse, in msvoid setup() { // initialize the buttons' inputs: pinMode(upButton, INPUT); pinMode(downButton, INPUT); pinMode(leftButton, INPUT); pinMode(rightButton, INPUT); pinMode(mouseButton, INPUT); // initialize mouse control: Mouse.begin();}void loop() { // read the buttons: int upState = digitalRead(upButton); int downState = digitalRead(downButton); int rightState = digitalRead(rightButton); int leftState = digitalRead(leftButton); int clickState = digitalRead(mouseButton); // calculate the movement distance based on the button states: int xDistance = (leftState - rightState) * range; int yDistance = (upState - downState) * range; // if X or Y is non-zero, move: if ((xDistance != 0) || (yDistance != 0)) { Mouse.move(xDistance, yDistance, 0); } // if the mouse button is pressed: if (clickState == HIGH) { // if the mouse is not pressed, press it: if (!Mouse.isPressed(MOUSE_LEFT)) { Mouse.press(MOUSE_LEFT); } } else { // else the mouse button is not pressed: // if the mouse is pressed, release it: if (Mouse.isPressed(MOUSE_LEFT)) { Mouse.release(MOUSE_LEFT); } } // a delay so the mouse does not move too fast: delay(responseDelay);}代码说明使用micro-USB线将电路板连接到计算机。按钮连接到引脚2至6的数字输入。确保使用10k下拉电阻。